- Wire Mesh Fence Series
- Anti Glare Fence
- Bending Fence
- Crimped Wire Mesh Fence
- Double Edge Fence
- Framed Fence
- Square Post Fence
- Welded Wire Mesh Fence
- Welded Wire Mesh Fence Panel
- Temporary Fence Series
- Australia Temporary Fence
- Canada Temporary Fence
- Crowd Control Barriers
- Temporary Chain Link Fence
- Temporary Fence Panels
- Temporary Fence Simple Feet
- Temporary Fence With Plastic Feet
- Chain Link Fence Series
- Aluminized Steel Chain Link Fence
- Black Vinyl Chain Link Fence
- Chain Link Type Wire Mesh
- Galvanized Chain Link Fence
- Industrial Chain Link Fence
- Outline of Chain Link Fence
- Plastic Coated Chain Link Fence
- Stadium Chain link Fence
- Agricul Ture Fence Series
- Dutch Mesh Fence
- Grassland Wire Mesh
- Holland Wire Mesh
- Garden And Residential Fence Series
- Garden Fence
- Ornamental Fence
- Residence Fence
- Roll Top Fence
- High Security Fence Series
- 358 Anti Climb Fence
- 3510 Security Fence
- Airport Fence
- Barbed Wire Fence
- Blunt Top Fence
- Double Wire Fence
- Paladin Fence
- Prison Fence
- Welded Razor Mesh Fence
- Razor Wire Series
- Concertina Cross Razor Wire
- Concertina Single Razor Wire
- Flat Razor Wire Fence
- Razor Barbed Wire
- Razor Wire Mobile Security Barrier
- Straight Type Razor Barbed Wire
- Welded Razor Mesh
- Fence Accessories Series
- Fence Accessories
- Fence Gate
- Fence Post
- Barbed Wire Series
- Double Twist Barbed Wire
- Galvanized Barbed Wire
- PVC Coated Barbed Wire
- Single Twist Barbed Wire
- Traditional Twist Barbed Wire
News
Wire mesh construction technology and quality control
We often see wire mesh in our daily life and it is favored by us. Next, we will explain the construction technology and quality control of wire mesh in detail.The connection between the pulling material and the upper beam and floor slab adopts the reinforcement code connection method. After determining the orientation of the plate, drill a round hole with a diameter of 6mm and a depth of more than 50mm in the beam and floor slab, use the round steel with a diameter of 6.5mm as the reinforcement code, pierce into the hole and fasten it, and then tie and connect it with the plate mesh with lead wire.
And ensure that the length of the bar code at the beam end is greater than 150mm, the length of the bar code at the floor end is greater than 200mm, and the distance between the bar codes of each plate width is about 600ram and not less than 3.
The connection between the plate and the wall and column adopts the reinforcement code. The requirements of reinforcement code and hole are the same as above. The distance between one reinforcement code located on the beam bottom or floor and the beam bottom or floor is 400ram. The center is evenly equipped with two mesh reinforcement codes, which are distributed at both ends.
The reinforcement and connection of plate splicing and pulling joint the strip double-sided reinforcement and connection method is selected for the plate splicing joint. Use lead wire to tightly tie the note with the wire mesh sheet of the plate. The distance between lead wire binding points is 400mm, and each binding node is at both ends of the same note. One for each other.